STEP BY STEP

STEP BY STEP

Como montar un circuito en la protoboard paso a paso:

STEP ONE:Inser,t BJT the transistor (each pin in a diferent row)
STEP TWO:check with the datashet which one ,is EMITER  BASE COLLECTOR.

STEP THREE:Correct the ground in the protoboard.
STEP FOUR:Brown black and yellow, put the resistor of 100k (linking the emisor and the base)

STEP FIVE:Inser,t the led linking the collector.
STEP SIX:Red,red and brown,insert the resistor of 220 volts between the led and VCC in the protoboard.

STEP SEVEN:Brown,black and red inser,t the resistor of 1k in the protoboard one pin linken VCC.
STEP EIGHT:Corret the wire walking as probe in the resistor of 1k

STEP NINE:Connet the battery to VCC and ground in the protoboard.